Scott was our tech/plumber this time, and installed a new garbage disposal for us. Scott was knowledgeable, efficient, and friendly. Before the visit, I spoke with Elek's warehouse to select the model Insinkerator I wanted. Most helpful. This is the third time I've used them. Prior to this they installed a new hot water heater on an emergency basis (very pleased with the rescue the day after Thanksgiving), and later to check out and service a sump pump. A very professional and service-oriented organization.read more
When a plumbing emergency strikes, you need dependable and quick service from a licensed, reputable Dallas plumber. Regardless of whether your emergency is a burst pipe that is causing water to flood into your home, a sewer line clog resulting in a backup of wastewater, or a gas leak; you can rely on a fast response from the licensed professionals at Baker Brothers Plumbing, Air Conditioning & Electrical. Our technicians are on call 24 hours a day, seven days a week.
Present-day water-supply systems use a network of high-pressure pumps, and pipes in buildings are now made of copper, brass, plastic (particularly cross-linked polyethylene called PEX, which is estimated to be used in 60% of single-family homes), or other nontoxic material. Due to its toxicity, most cities moved away from lead water-supply piping by the 1920s in the United States, although lead pipes were approved by national plumbing codes into the 1980s, and lead was used in plumbing solder for drinking water until it was banned in 1986. Drain and vent lines are made of plastic, steel, cast-iron, or lead.
Most plumbers wont mess with the septic tank. We deal mostly with components inside the house. Did you have a vent pipe in the yard (often looks like a candy cane made of PVC) before the repair but not after? If all he did was replace the line it shouldn't cause a smell inside the house. All plumbing fixtures inside the house should have properly functioning traps. Those traps would create and maintain a water seal against the sewer gases. You should have at least one vent through the roof to equalize pressures within the drainage system. This prevents positive pressures within the system (caused by fixtures discharging into the lines, ie toilet flush) from pushing gas out through the traps, and negative pressures (the waste in line will pull air behind it like your finger over the end of a straw) from sucking water out of the traps.
Periodic maintenance is the single most important activity you can perform to protect the ROI on your plumbing assets, ensure system efficiency and uptime, and maximize the life of your equipment. With ACCO as your service partner, you benefit from decades of plumbing engineering expertise and industry leading technical know-how. Please visit our Preventive Maintenance page for more info.
Are you looking to buy a new AC? It is important to make the right choice. ACs come in all sizes and types. You have to choose the one that suits you the best. It has to be a combination of right price and performance. Finding the AC that is suitable for your room can be tricky. It is one of the important things to take care of while getting a new AC. Installing the new AC correctly is equally important. Such a service can only come through a technician that has experience. Only with the right combination of skill and experience can you get the best install.
Wooden pipes were used in London and elsewhere during the 16th and 17th centuries. The pipes were hollowed-out logs, which were tapered at the end with a small hole in which the water would pass through. The multiple pipes were then sealed together with hot animal fat. They were often used in Montreal and Boston in the 1800s, and built-up wooden tubes were widely used in the USA during the 20th century. These pipes, used in place of corrugated iron or reinforced concrete pipes, were made of sections cut from short lengths of wood. Locking of adjacent rings with hardwood dowel pins produced a flexible structure. About 100,000 feet of these wooden pipes were installed during WW2 in drainage culverts, storm sewers and conduits, under highways and at army camps, naval stations, airfields and ordnance plants.
Last night my kitchen sink decided to start draining slowly so I paid a guy on taskrabbit to come out and unclog the issue... yeah no. he made a mess dripping black slime everyplace and left me with a sink that not only did not drain, but now the piped leaked! YAY thanks! I learned my lesson, im trusting real plumbers from now on :/ texted them at 11pm and they were able to come out first thing this morning. Fixed the clog, cleared the pipes out, and replaced our hot mess cluster of pipes from the previous owner with one clean new pvc pipe.
"lead hung on a string to show the vertical line," early 14c., from Old French *plombe, plomee "sounding lead," and directly from Late Latin *plumba, originally plural of Latin plumbum "lead (the metal), lead ball; pipe; pencil," a word of unknown origin, related to Greek molybdos "lead" (dialectal bolimos) and perhaps from an extinct Mediterranean language, perhaps Iberian.
If nothing inside the home was altered you should not be getting a smell. Personally I'm confused as to why the repair person would have left the original line there and ran another one through a new hole. I would have pulled the old line up, ran the new line (in PVC) and used the same hole in the septic tank instead of creating a new one. Did he seal up the hole in the tank from the old line?
According to standards set by the federal government, a low-flow showerhead uses no more than 2.5 gallons of water per minute at a water pressure of 80 pounds per square inch. That’s less than half the rate of water used by some older traditional showerhead models. Low-flow showerheads come in two main types, aerating, which creates a mist, or laminar-flow that sends water out in a steady stream.
Plumbers, pipefitters, and steamfitters may use many different materials and construction techniques, depending on the type of project. Residential water systems, for example, use copper, steel, and plastic pipe that one or two plumbers can install. Power plant water systems, by contrast, are made of large steel pipes that usually take a crew of pipefitters to install. Some workers install stainless steel pipes on dairy farms and in factories, mainly to prevent contamination.
CON'T FROM COMMENTS EARLIER. However, the installation took less than 3/4/ hour and was a basic regulator with no other function. Looking up the price afterwards, invoice did not list type or price, it appears that it would have cost me around $60 for the regulator and another $15 or so for the additional supplies necessary to install it and it was really a rather simple job with easy access. Given that, it seems that $300 for less that an hours worth of on site work, company says it does not include commute time in its prices, is a little high. While flat rate quotes are nice, they must take into consideration situations where the work load differs depending on the circumstances. Therefore, unless you are at the upper end of the harder work needed than the average job. it can be argued that my estimated price of $300 for labor was more than a little high. Maybe I am wrong since I have not used their services for years and am not knowledgeable of the costs of equipment and professional labor today.
Some allege that putting a brick in the toilet tank can save water, but doing that can keep your toilet from flushing correctly. Another plumbing tip, avoid liquid drain cleaners. Liquid drain cleaners are also bad news—they eat away at the pipes. Try a plunger or, better yet, a $30 auger. Don’t have either? Here’s how to unclog a toilet without a plunger.
I used Go Green Express Home Services for a minor plastic pipe repair under my kitchen sink...The worker did a great job fixing this minor pipe plastic pipe repair( my original pipe was too short and he needed to extended the pipe and then reconnect). It took him less than 10 minutes to fix. I was first quoted $125 +tax but when the worker went to his truck and spoke to whoever he spoke to at the office, the price rose to $155.10 +tax for a total of $167.10...I thought that was a little too high. Will I use this company again, I Don't Know. It would be helpful if they would have a set price list for jobs (minor repairs, Major repairs etc...), then you as the consumer can see beforehand what the cost maybe and work from there with the company. Minor repairs, Major repairs this company should at least have a set-price list. ..The worker was great and efficient and did a good job on the repair but their prices are a bit costly. And yes, I did write this in their review.
Average Americans work well into their 60s, so workers might as well have a job that’s enjoyable and a career that's fulfilling. A job with a low stress level, good work-life balance and solid prospects to improve, get promoted and earn a higher salary would make many employees happy. Here's how Plumbers job satisfaction is rated in terms of upward mobility, stress level and flexibility.
Excellent service! From just the way my first telephone call was handled I knew I had call the right company...so attentive , reassuring and professional. Mr. Flinn arrived right away and as he was on the first call so nice. He immediately cleared the sewer line but since this was his second service call to my home he recommended for a permanent solution I might want to call a company that could inspect the line with a camera and if necessary replace it. I asked for a recommendation and the company he recommended was excellent. You can not go wrong calling Flinn's Rooter Service, professional, rapid service and fair pricing.
The trick to caulking tubs and showers is using the right type of caulk. There are many different kinds of caulk out there that are used for home repair, from filling cracks in drywall to sealing off plumbing appliances. Make sure you check the label, and only get caulk that is designed for tubs and showers, or ask someone at the hardware store for help. Go for quality when you purchase a caulking gun. They aren't that expensive, and they are easier to use and last longer.
The scenario is similar when it comes to hiring an electrician. The Chandler is full of novice technicians who provide lousy services. You can never rely on such workmen to provide you with good work. They will always lag in some aspect or the other. Some technicians charge a fee that is too high. These are the workmen who rip-off the customer and do not care about him. Other technicians do not use genuine parts. This leads to the coming back of the issue within a few days. You have to strike the right balance.
For details about apprenticeship or other opportunities in this occupation, contact the offices of the state employment service; the state apprenticeship agency; local plumbing, heating, and cooling contractors or firms that employ fitters; or local union–management apprenticeship committees. Apprenticeship information is available from the U.S. Department of Labor's Apprenticeship program online, or by phone at 877-872-5627.