"They replaced the entire sewer line from the house to the street using a technique called “pipe bursting” where they pull a new line through the old line. We used a coupon where for $93 they freed up a clog in our old line and put a camera down the line to figure out what the problem was... I like that they didn’t have to dig up my yard for this particular technique..."
“I have used Central Penn for many repairs/installs over the last 15 years. They have always responded in a prompt manner and I found their people to be very friendly, efficient and competent in diagnosing and repairing any issues I had, whether related to plumbing or HVAC. Furthermore, which you can’t take for granted these days, the guys are very respectful of your home and are careful in their work and thoroughly clean up after the job is completed.”
Each Government at the state level has their own Authority and regulations in place for licensing plumbers. They are also responsible for the interpretation, administration and enforcement of the regulations outlined in the NCC. These Authorities are usually established for the sole purpose of regulating plumbing activities in their respective states/territories. However, several state level regulation acts are quite outdated, with some still operating on local policies introduced more than a decade ago. This has led to an increase in plumbing regulatory issues not covered under current policy, and as such, many policies are currently being updated to cover these more modern issues. The updates include changed to the minimum experience and training requirements for licensing, additional work standards for new and more specific kinds of plumbing, as well as adopting the Plumbing Code of Australia into state regulations in an effort to standardise plumbing regulations across the country.
The straight sections of plumbing systems are called "pipes" or "tubes". A pipe is typically formed via casting or welding, whereas a tube is made through extrusion. Pipe normally has thicker walls and may be threaded or welded, while tubing is thinner-walled and requires special joining techniques such as brazing, compression fitting, crimping, or for plastics, solvent welding. These joining techniques are discussed in more detail in the piping and plumbing fittings article.
toilets work off of siphon.more correctly it's the timely transfer of water from the tank to the bowl through the ports that starts the siphon and carrys the solids and water downstream,thus completing a flush.i also live in florida and due to lots of hard water everywhere can tell you that most likely the toilets are full of deposits and need to be replaced or are of poor quality.all of the toilets from home depot are trash i would suggest getting one from the factory or from a plumbing supply house.DO NOT GET A 1.28gpf...1.6gpf is still legal
I had 207 Plumbing come to fix a leak in my ceiling. It's a terrible, terrible company to do business with. He came and fixed a broken pipe in the ceiling, and I asked him to check the rest of the pipe to make sure that nothing else was broken, he said everything was OK and charged me $219.00 for 45 minutes and left. Never cleaned up his mess. I went to clean up the mess after he left and found there was more damage to the pipe. I called him to come back, which he did. He looked at the water coming down from the ceiling, into a light fixture and said he had another job to go to and couldn't come back until next week. He also wanted to charge me $350.00 to come back. I told him that was too much and he said he would make an exception and only charge me $219.00. Now I have major damage done to the ceiling, the light fixture and the floor. All of this could have been prevented if he had stayed and fixed the problem. I will NOT hire him again.
I used Flynn's in Dec 2014 right after I purchased a home in Chesterfield and had a "stand still" clogged line to the septic. A young fellow came over, right on time, cleared the septic line, charged a reasonable fee, and we were done. What more can you ask for? I am currently experiencing another issue and will be calling Flynn's again to fix it!
Need a plumber? Tap us! We repair clogged drains, busted pipes and any other broken plumbing fixtures. Apollo Drain & Rooter Services takes care of more than basic plumbing jobs. We also specialize in excavations, large-scale projects and trenchless-pipe replacement. If you need a plumbing company for your Portland, Oregon area home or business, we can help with your drain repair.
Sometimes you might need your sewer and drain lines inspected. For instance, if your sewage is backed up, then you probably want to determine what the cause is. In instances where we can't physically get to the problem to see what it is, we can use a sewer video camera to go down into your lines and take a video showing us what's the issue then. That way we'll know the appropriate way to deal with it.